BITUPRIMER - D41

Request a Quote
Download TDS

DESCRIPTION

Bituprimer D‐41 is a solvent based bituminous primer suitable for general purpose roofing primer used as dressing to concrete, masonry and metal surface and as a primer coat prior to application of BITUGULF membranes.

SPECIFICATION

APPROVALS / CERTIFICATES

USES

STORAGE

  • Keep the products packed in a dry place.
  • Keep away from direct sunlight.
  • Do not place the pallets on top of each other
  • Use only with proper ventilation.
  • Avoid contact skin and eyes by careful working.
  • Do not use near open flame.
  • It is advisable to use goggles and gloves.
  • In case of eye contact immediately wash with cold water or consult the physician.

DRYING TIME

  • General purpose primer for concrete, masonry and metal surfaces.
  • As priming coat before applying and bituminous coating.
  • As priming coat before applying any waterproofing membrane.
  • Suitable for use as primer below or above ground level.

SURFACE CLEANING

APPLICATION

  • A cold applied solvent based bituminous primer
  • A bituminous liquid primer penetrates deep into the porous substrates to improve the adhesion of bituminous materials that are to be applied to the substrate.
  • Conforms to the requirements of ASTM D41.

COVERAGE RATE

Coverage rate varies from 0.3 ‐ 0.5 kg/sq.mt depending on application method, surface properties and condition of substrates.

PRIMING

APPLICATION TOOLS AND EQUIPMENT

  • The surface must be thoroughly cleaned and free from dust, dirt, oil, and grease
  • Bituprimer D‐41 should be well stirred prior to use and applied to the substrate by means of brush, roller or spray.
  • After application don’t leave the primer exposed for more than 12‐hours, if this should be the case, apply a further coat and allow curing.
  • Tools may be cleaned with any suitable solvents such as gasoline or kerosene.

HEALTH, SAFETY AND ENVIRONMENT

All safety measures should be observed during application. Fire extinguishers should be available on site. Care should be taken with gas, and torches should not be rested on finished surface or on any
materials that can be scratched by flame or hot torch. Gloves and goggles should be worn by all workers during application.

Read, understand and follow all Material Safety Data Sheets and product label information for this product prior to use.

TECHNICAL SUPPORT

International Insulation Company (IIC) – Bitugulf technical support team consists of expert engineers offers a comprehensive service support to specifiers, end users and contractors, and on- site technical assistance.

Note: The technical data provided reflects typical properties based on laboratory tests and practical experience, subject to UEAtc tolerance levels. While we cannot guarantee performance under all conditions, further details are available upon request, with a standard variation of up to 20%.

TECHNICAL DATA